Parts

How to put together a printed Photon grip. The pictures show the right-hand grip at the model’s defaults; a left-hand grip is its mirror image and goes together the same way.

You need the 14 printed parts, a cord for the anchor, a mallet or hammer with a small wood block, and optionally an inert lubricant such as Super Lube.

The middle and index walls look alike: label them as you take them off the plate (the slicer’s object list names every part).

Part		How to recognize it
Frame		The largest part, with the top crossbar engraved Crimpdeq Photon and the cord hole
Ring wall		Round hump around a pin hole
Middle wall		Looks like the index wall
Index wall		Looks like the middle wall
End wall		Thin plate engraved crimpdeq.com
Pinky roller		30 mm, one narrow and one wide end
Ring, middle and index rollers (3)		19 mm, both ends the same
Pinky pin		The longer pin, about 36 mm
Ring, middle and index pins (3)		About 25 mm, interchangeable
Post		Long square bar, about 105 mm, one corner chamfered

The illustrations come from the OpenSCAD model; regenerate them with docs/illustrations/render.sh.